Use this information to remove a storage tray from a NeXtScale nx360 M4 compute node.
Before you remove a
storage tray from a
compute node, complete the following steps:
- Read Safety and Installation guidelines.
- If the compute node is operating, shut down the operating system.
- Press the power button to turn off the compute node (see Turning off the compute node for
more information).
To remove the storage tray from
a compute node, complete the following steps:
- Remove the easy-swap hard disk drive #6 (see Removing a 3.5-inch hard disk drive).
- Disconnect the configuration cable, the hardware RAID (signal)
cable, and the mini-SAS cable from the storage tray.
- Press on the release latch and slide the storage tray toward
the rear of the compute node.
Figure 1. Removal
of a storage tray
- Pull the storage tray out
of the compute node.
If you are instructed to return the storage tray, follow all packaging instructions, and use any packaging materials
for shipping that are supplied to you.