Use these instructions to remove the fan power control from the NeXtScale n1200 Enclosure.
- Disconnect all cables from the fan power control.
- If you want to migrate current chassis settings and the chassis
midplane VPD onto the new fan power control, make sure you have done the following:
- You had performed FPC settings
backup, the chassis VPD backup, and the midplane VPD backup procedures
(see System information options).
- Keep the old USB key which is from the fan power control to be
removed and install it onto the new fan power control.
To remove an fan power control,
complete the following steps.
Figure 1. Removal of an
fan power control from
the chassis
- Open the release handle (rotate the handle down) to disengage
the fan power control from
the chassis.
- Slide the module out of the fan power control bay and place
it on a flat, static-protective surface.