The default settings for the Power Policy option are set
by the IMM2.
To change the Power Policy option to the default settings,
complete the following steps.
-
Turn on the server.
Note: Approximately 20 seconds
after the server is connected to AC power, the power-control button
becomes active.
-
When the prompt <F1> Setup is
displayed, press F1. If you have set an administrator
password, you must type the administrator password to access the full
Setup utility menu. If you do not type the administrator password,
a limited Setup utility menu is available.
-
Select ,
then set Power Restore Policy setting to Restore.
-
Go back to .
-
Go back and check the Power Policy setting
to verify that it is set to Restore (the default).
Attention: If you set an administrator password
and then forget it, there is no way to change, override, or remove
it. You must replace the system board.