The power-control button does not work, and the
reset button does not work (the server does not start). Note: The
power-control button will not function until approximately 5 to 10
seconds after the server has been connected to power.
|
- Make sure that the power-control button is working correctly:
- Disconnect the server power cords.
- Reconnect the power cords.
- (Trained technician only) Reseat the operator information panel
cable, and then repeat steps 1a and 1b.
- (Trained technician only) If the server starts, reseat the operator
information panel. If the problem remains, replace the operator information
panel.
- If the server does not start, bypass the power-control button
by using the force power-on jumper (see System-board switches and jumpers). If the server starts, reseat the operator
information panel. If the problem remains, replace the operator information
panel.
- Make sure that the reset button is working correctly:
- Disconnect the server power cord.
- Reconnect the power cord.
- Make sure that :
- The power cords are correctly connected to the server and to a
working electrical outlet.
- The type of memory that is installed is correct.
- The DIMM is fully seated.
- The LEDs on the power supply do not indicate a problem.
- (Trained technician only) The microprocessors are installed in
the correct sequence.
- Reseat the following components:
- DIMMs
- (Trained technician only) Power-supply cables to all internal
components
- (Trained technician only) Power switch connector
- Replace the following components one at a time, in the order shown,
restarting the server each time:
- DIMMs
- Power supply
- (Trained technician only) System board
- If you just installed an optional device, remove it, and restart
the server. If the server now starts, you might have installed more
devices than the power supply supports.
- See Power-supply LEDs.
- See Solving undetermined problems.
|
The server does not turn off. |
- Determine whether you are using an Advanced Configuration and
Power Interface (ACPI) or a non-ACPI operating system. If you are
using a non-ACPI operating system, complete the following steps:
- Press Ctrl+Alt+Delete.
- Turn off the server by pressing the power-control button for 5
seconds.
- Restart the server.
- If the server fails POST and the power-control button does not
work, disconnect the power cord for 5 seconds; then, reconnect the
power cord and restart the server.
- If the problem remains or if you are using an ACPI-aware operating
system, suspect the system board.
|
The server unexpectedly shuts down, and the LEDs
on the operator information panel are not lit. |
See Solving undetermined problems. |