This section provides information about routing the cables
when you install some components in the Lenovo NeXtScale nx360 M5 compute node.
The following notes describe additional information you must consider
when you install or remove the cables:
- To remove the cables, slightly press the cables toward the planar
tray; then, pull to remove the cables from the connectors on the system
board. Pulling the cable out of the connector by excessive force might
cause damage to the cable or connector.
- To connect the cables on the system board, press evenly on the
cables. Pressing on one side of the cable might cause damage to the
cable or connector.
- Make sure that the cables are not pinched and do not cover any
connector or obstruct any component on the system board.
- Make sure that all cables above the power paddle card not crossing
each other.
For more information about the requirements for cables and connecting
devices, see the documentation that comes with these devices.