Removing the bezel

Use this information to remove the bezel.

Before you remove the bezel, complete the following steps:
  1. Read Safety and Installation guidelines.
  2. If the compute node is installed in a NeXtScale n1200 Enclosure, remove it (see Removing a compute node from a chassis for instructions).
  3. Carefully lay the compute node on a flat, static-protective surface, orienting the compute node with the bezel pointing toward you.

To remove the bezel, complete the following steps:

  1. Remove the cover (see Removing the compute node cover).
  2. Remove the two hex screws by hex screwdriver.
    Figure 1. Hex screws removal
    Hex screws removal
  3. Remove the three M3 screws by T8 torx screwdriver (provided on the back of the chassis).
    Figure 2. M3 screws removal
    M3 screws removal
  4. Remove the caming handle screw by Phillips screwdirver #2.
    Figure 3. Caming handle screw removal
    Caming handle screw removal
  5. Remove the four M3 screws by T8 torx screwdriver (provided on the back of the chassis).
    Figure 4. M3 screws removal
    M3 screws removal
  6. Grasp the bezel and remove the bezel out of the compute node.
    Figure 5. Front bezel removal
    Front bezel removal