Use this information to install the USB flash drive.
Before you install the USB flash drive, complete the following
steps:
- Read Safety and Installation guidelines.
- If the fan power control is installed in the NeXtScale n1200 Enclosure, remove it (see Removing the fan power control).
- Carefully lay the compute node on a flat, static-protective surface,
orienting the compute node with the bezel pointing toward you.
This component can be installed
as an optional device or as a CRU. The installation procedure is the
same for the optional device and the CRU.
To install the USB flash drive, complete the following
steps.
Figure 1. Installing USB flash drive
- Locate the USB connector on the fan power control.
- Push the USB flash drive into the connector.
After you install the USB flash drive, Install the
fan power control into the chassis (see
Replacing an fan power control).