Use this information to install the hard disk drive backplate.
Before you install the hard disk drive backplate, complete
the following steps:
- Read Safety and Installation guidelines.
- If the compute node is installed in a NeXtScale n1200 Enclosure,
remove it (see Removing a compute node from a chassis for
instructions).
- Carefully lay the compute node on a flat, static-protective surface,
orienting the compute node with the bezel pointing toward you.
The default setting of 4 switches in SW1 are all “OFF”. Please
make sure the switch-1 in SW1 is set to “ON” before you install the
4x2.5-inch hot-swap drive backplate as the following illustration.
Figure 1. Switch setting
To install the hard disk drive backplate, complete the
following steps.
Figure 2. Installing backplate for 2.5-inch
Figure 3. Installing backplate for 1.8-inch
-
Remove the cover (see Removing the compute node cover).
-
Remove the hard disk drives (see Removing and installing drives).
-
Align the backplate with the hard disk drive cage and press
the backplate into position.
-
Close the release latch.
-
Connect the power cable and signal cables to planar connectors
or the RAID adapter.
-
Slide the hard disk drive into the bay until it is firmly
seated in the connector.
-
For the 1.8-inch solid-state drives, lock the hard disk
drive into place by closing the release lever.
After you install the hard disk drive backplate, complete
the following steps:
- Install the cover onto the compute node (see Installing the compute node cover for instructions).
- Install the compute node into the chassis (see Installing a compute node in a chassis for
instructions).