Use this information to remove the power distribution board.
Read the safety information in Safety and Installation guidelines.
If you are replacing a server component in the water-cooled technology tray, you need to remove the water-cooled technology tray from the chassis enclosure and refer to the Removing a water-cooled technology tray from a chassis and Installing a water-cooled technology tray in a chassis sections.
To remove the distribution board, complete the following steps:
- Remove the screws on the rear bulkhead bracket. The screw
on the rear is a T8 Torx screw while the other screws are T10 TorxFigure 1. Rear bulkhead bracket screws removal
- Remove the rear bulkhead bracket.Figure 2. Rear bulkhead bracket removal
- Remove the three screws that secure the power distribution
board to the water-cooled technology tray and
save them for future use.Figure 3. Power distribution board screws removal
- Remove the power distribution board out of the water-cooled technology tray with
an angle.Figure 4. Power distribution board removal
If you are instructed to return the server component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.