Use this information to remove a copper water loop.
Attention:
- Copper water loop supports Intel Xeon E5-2600 v3 and v4 series.
- Water loop is to be installed only by trained technicians.
- Do not touch the microprocessor contacts; handle the microprocessor
by the edges only. Contaminants on the microprocessor contacts, such
as oil from your skin, can cause connection failures between the contacts
and the socket.
- The pins on the sockets are fragile. Any damage to the pins might
require replacing the system board.
Read the safety information in Safety and Installation guidelines.
If you are replacing a server component in the water-cooled technology tray, you need to remove the water-cooled technology tray from the chassis enclosure and refer to the Removing a water-cooled technology tray from a chassis and Installing a water-cooled technology tray in a chassis sections.
To remove a water loop, complete the following steps.
- Remove the cover (see Removing the cover).
- Remove the cross brace.
Figure 1. Cross brace removal
- Remove the front and rear clamp plates (12 screws).
Figure 2. Clamp plates removal
- Loosen cold plate captive screws (16 screws).
Figure 3. Loosen cold plate captive screws
- Remove air baffles from rear of the node 2x places.
- Remove quick connection assembly screws (8 screws).
Figure 4. Quick connection assembly screws removal
- Unhook the quick connection assemblies from the planar
tray.
Figure 5. Unhook the quick connection assemblies from the planar tray
- Remove the copper water loop from the planar tray.
Figure 6. Copper water loop removal
If you are instructed to return the server component
or optional device, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.